You may recall that I started a baby blanket for my niece a little while ago, and knitted quite a bit of the centre of it on my holidays. I finally finished it and my parents kindly stuffed it in their suitcase when they flew over to meet Jennifer at the end of October.

The pattern is a fairly traditional Shetland hap pattern from Chris Williams’s Lace Class. The inside square is garter stitch knitted on the bias. There is then a border of feather and fan pattern, and then a sideways knitted simple garter stitch lace edging.

It was very enjoyable to knit, and although Jenny is a little young to be expressing an opinion on these things her parents seem to like it 🙂

I used 6 x 50g of Sirdar Snuggly 4ply, 55% nylon, 45% acrylic, and 4mm needles.

The blocking was slightly scary. Being nylon and acrylic you have to be a bit careful with blocking if you use steam. However if you pin out your blanket and steam it very gently it will actually set the stitches so that it wont need blocking after subsequent washing. The careful part is key here since you have to be very careful not to totally melt your yarn! As you hover with the steam you can actually see the stitches relaxing (permanently!). A lie down in a darkened room is recommended after you do this.

It all went ok though, and hopefully this will save the blanket from needing to be reblocked while still being easily washable.